After first power up, at least basic configuration should be performed in order to setup proper interfaces IP configuration. This can be done using front panel keyboard.

To enter setup mode press and hold “OK” button. Now you can configure LAN1 interface. Following screens will appear on LCD:

 LAN1 IP address:

192.168.000.210

 LAN1    netmask:

255.255.255.000

LAN1   gateway:

192.168.000.001

To navigate through digits use “left arrow” and “right arrow” keys. To increase values use “up arrow” key, to decrease use “dwon arrow” key. One can instantly clear currently edited parameter to zeros by pressing “C” key. Pressing “OK” button switches to next parameter. After configuring LAN1 interface, LAN2 interface screens are shown. After configuring all parameters following screen is shown:

Are     you     sure ?

[OK]-Yes [Cancel]-No

In order to save configuration press “OK” button. NTS-xxxx will reboot and operate with new setting. If you want to keep old configuration simply press “C” button and no changes will be made. In order to exit from configuration mode just press “OK” button as many times as needed to obtain confirmation screen and then press “C” button. This operation must be done with caution in order to avoid saving bad settings.

This method allows only base LAN interfaces configuration. In order to change other NTS-xxxx settings console configuration option is available.