Time Server

NTS-3000, NTS-4000, NTS-5000, NTS-dialup

User Manual

 

Select chapter: 1 , 2 , 3 , 4 , 5 , 6 , 7 , 8 , 9 , 10 , 11 , 12 , 12.1, 12.2, 12.3

 

Before you start reading manual !

This manual is dedicated for all Time Servers manufactured by Elproma including:     

NTS-3000, NTS-4000, NTS-5000, NTS-7000, NTS-9000 and NTS-dialup

called later shrtly "NTS-xxxx". Some model related differences are clearly highlighted.

 

 

 

Contents

 

 

 

 

Safety instructions

 

1.     Introduction

2.     Hardware

3.     Mounting GPS antenna

4.     Powering up NTS time server

5.     Basic device configuration

6.     Error messages

7.     NTP – Network Time Protocol

8.     NTP on Time Failure Tolerance Network

9.     NTS time server software Setup

10.   Security and NTP authentication mode

11.   NTPq client diagnostic utility

12.   Installing NTP client software

12.1. Windows 95/98/Me (SNTP client)

12.2. Windows NT/2K/XP/2003/Vista (NTP Client)

12.3. UNIX family systems

   --- End of manual ---

 

 

 

 

SAFETY INSTRUCTIONS

 

 

This are the important Safety Instructions that should be followed during installation and maintenance of the Elproma NTS-xxxx time server products.

IMPRTANT NOTE !

This equipment contains hazardous voltages. Do not handle any metallic part until the power has been disconnected. Do not assemble, disassemble set when the power is ON. Making wiring and touching cables is strongly prohibited when power is ON. Please refer to your RACK’19 safety instruction to learn more about connecting power to equipment. The NTS-protection system requires PE line to be connected into RACK’19 din rails.

Elproma safety advices:

1. Do not work alone under hazardous conditions.

2. High short circuit current trough conductive materials

   can cause severe burns.

3. Check that the power cord(s), plug(s), and sockets are in good conditions.

4. Use qualified service personnel to install permanently wired equipment.

5. Do not handle any metallic part before the power has been disconnected.

6. Take care your power lines and rack'19 frame are properly grounded.

                                                                                                                                                                  ELPROMA Team

 

For surge, overvoltage  and lighting protection please refar to NTS-protect product available separately.

 

 

Home Page                                                                             Top of page                                                                                Next Page